Service area
Commercial caulking in Englewood
Panel joints, EIFS, window perimeters and garage expansion joints for Englewood commercial buildings, from Buckley Joint Sealants in Aurora, with every job quoted against published pricing.
Call (720) 699-9924Englewood is where the metro’s older industrial building stock lives. The corridor along Santa Fe Drive and the rail line is CMU block, brick and early tilt-up from the 1960s through the 1980s, buildings that have outlasted several tenants and several rounds of sealant. Masonry control joints on those walls have often been caulked three times, and the last round is frequently a hardware store product smeared over the last, which is exactly the condition that fails within a couple of winters.
On the east side, Englewood addresses cover a big share of Inverness, where the 1980s and 1990s precast and tilt-up office and flex buildings are on the same reseal schedule as Centennial next door. And the hospital and medical office buildings around Swedish Medical Center bring a third kind of work: occupied healthcare buildings where the sequence, the hours and the dust control matter as much as the sealant.
Buckley Joint Sealants handles Englewood’s masonry joints the way the joint was designed: full removal to clean block or brick, new backer rod, primer where the masonry needs it, and a urethane or silicone sized to the joint. Older buildings sometimes need joint edge repair before sealing, and that is shown at the survey and itemized, never discovered after the crew is on site.
Layered sealant, the Englewood special
On the Santa Fe corridor buildings we frequently find that the last recaulk was done without removing the old bead, so there are two and sometimes three layers of incompatible sealant in the joint. Silicone over urethane never bonds. The only fix is cutting the whole stack out, which is why those joints price at the top of the range the first time and the bottom of the range the next.
Englewood districts and campuses
- the Santa Fe Drive industrial corridor
- Inverness Drive East and West
- Swedish Medical Center campus
- CityCenter Englewood
- South Broadway retail
ZIP codes: 80110, 80112, 80113
Englewood owners ask about
Our block building has vertical cracks at the control joints. Is that a masonry problem?
If the crack is inside the joint, it is sealant doing its job of failing before the block does, and recaulking is the fix. If the crack runs through the block faces beside the joint, the wall is moving more than the joint allows and a mason should look first. We tell you which at the survey and do not quote sealant over a masonry problem.
Can you work on a medical office building during business hours?
Yes, with restrictions we agree with facilities in advance: no work at patient entrances during clinic hours, low odor sealants where required, and no lift movement near ambulance bays. Most medical exteriors are done in early morning blocks.
What does it cost to recaulk a 20,000 square foot block warehouse?
Control joints on a building that size usually total 400 to 800 linear feet, mostly ground and ladder reach. At published rates that commonly lands between $3,000 and $8,000, with joint edge repair, if needed, itemized on top.
Do you seal roof to wall joints or is that the roofer?
The counterflashing and the roof membrane termination are the roofer’s. The wall joint below the flashing, and the parapet cap joints, are ours. Leaks at that line often need both, and we coordinate with your roofer rather than guessing.
Nearby areas we also cover: Commerce City · Parker · Lone Tree · all service areas. Pricing for every joint type is on the cost guide.
Survey an Englewood building
Free survey, written per foot quote, no obligation.